Geothermal Heat Pump Installation Services

Geothermal Heat Pump Installation

Denver’s elevation requires efficiency derating in every load calculation, we build that step in from the first enquiry. You receive a written, itemised estimate covering loop field configuration, BTU capacity, and permitting before an installer is booked.

Geothermal Heat Pump Maintenance

A ground-source system running at reduced loop pressure or low refrigerant charge loses BTU capacity quietly, you notice it on the utility bill, not the thermostat. Scheduled maintenance visits inspect loop fluid levels, heat exchanger fouling, and electrical connections to keep output at rated capacity.

Geothermal Heat Pump Repair

A geothermal system that short-cycles, loses heating capacity, or trips a fault code needs diagnosis before parts are ordered. We arrange a licensed installer to identify whether the fault sits in the refrigerant circuit, loop field, or controls, and provide a written itemised scope before any repair begins.

Geothermal Heat Pump Replacement

Replacing an aging ground-source unit is an opportunity to right-size the system if the original installation was undersized for your current load. We assess whether the existing loop field can carry the new unit’s BTU demand, then arrange an installer with a written, itemised estimate covering equipment and any loop modifications.

Geothermal System Consultation

A consultation answers whether a ground-source system is viable for your property before you commit to any cost. We review your lot dimensions, soil or water access, estimated BTU load, and applicable county permitting rules, then provide a written summary of loop field options and indicative project scope.

Ground Loop Repair

A loop field leak or flow restriction cuts the heat exchange capacity your system was sized to deliver. We arrange a licensed installer to locate the fault using pressure testing, excavate or access only the affected section, and verify loop pressure and flow rate after the repair is complete.

Horizontal Loop Installation

Horizontal loops are trenched at 4-6 feet depth across your available land area, making them cost-effective where acreage allows. We arrange an installer to calculate the required trench footage from your altitude-adjusted BTU load, assess soil thermal conductivity, and provide a written estimate before any digging begins.

Indoor Heat Pump Unit Installation

The indoor unit must be matched to the loop field’s heat exchange capacity and your home’s distribution system, oversizing or undersizing either side wastes the efficiency the ground-source loop delivers. We arrange installation with a written scope covering unit specification, ductwork or hydronic connections, and commissioning checks.

Mechanical Component Repair

Mechanical faults in a ground-source heat pump, a failing compressor, a worn circulation pump, or a leaking heat exchanger, each require different parts and labour. We arrange a licensed installer to diagnose the specific component, provide a written itemised scope, and confirm BTU output after the repair.

Open Loop Installation

An open loop draws groundwater or surface water through the heat exchanger and discharges it, delivering high efficiency where water supply and discharge permits allow. We confirm water rights, flow rate adequacy, and Colorado discharge requirements before scoping the installation, so compliance issues don’t surface mid-project.

Pond Lake Loop Installation

A pond or lake loop submerges coiled pipe at sufficient depth to maintain stable water temperature year-round, avoiding the cost of vertical boring. We verify that your water body meets Colorado’s minimum depth and surface area requirements, then arrange installation with a written scope covering coil sizing and freeze protection.

Vertical Loop Installation

Vertical loops require a drilling rig to bore 150-400 feet per ton of capacity, making them the practical choice for urban and suburban lots where horizontal trenching isn’t feasible. We arrange an installer to calculate boring depth from your altitude-adjusted BTU load and provide a written estimate before any drilling begins.